3D MODEL DESCRIPTION this replaces the plastic tab that latches into the plastic trim of the car holding the cover open.
mine was broken when i purchased the car so i created this to fix it
3D PRINTING SETTINGS 0.1 layer height 0.4 nozzle in pla use support and orient the parts so the outside of each half is up this leaves a flat layer to glue together after removing the support material flip the part as necessary to replace the side that is damaged remove the rivet from the broken piece using a flat head screwdriver under the washer or drill out with a 4mm (5/32") drill, remove the broken plastic, check the fitment of the new piece, glue both halves together using superglue making sure the hole lines up, make sure all superglue is cured then push over the metal tab and install a m4 pan head screw into the recessed side and use the original washer and a m4 nut on the back side to secure.