Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5602311.
I made this " Pin support challenge" but on Tinkercad with Cura, not Full control XYZ. So this is a close clone but not the same. It still does circles for the base. I am curious to see if someone can address this with the same setup. I have tried without the brim support and have yet to pull that off correctly. This is a 10mm sphere with a 9mm void, a 1mm tall dome cap inverted for first 3 layers of sphere, a 1mm cone pulled up past the sphere for a tapered union at the sphere's lower union, and cut off at the top. I added a 2mmx1mm disc for support on the bottom to attempt without brim. *I highly suggest going to fullcontrolxyz and just make your own G code there. If you saw my video on TikTok, it's not this file. That one I made on FullControlXYZ.