A beautiful trash can suitable for your home, office and especially bathroom. Compared to its size it uses little material and is very sturdy. The container can be used with or without the print-in-place swing lid.
Included versions: A: Regular
-
Body_regular: The body with a height of 230 mm (default) and a thickness of 0.8 mm
-
Body_regular_lower: The body with a height of 210 mm and a thickness of 0.8 mm
-
Body_regular_thicker: The body with a height of 230 mm and a thickness of 1.2 mm
-
Body_regular_weight: The body with a height of 230 mm, a thickness of 0.8 mm and space to insert weights during the printing process – instructions can be found below
-
Lid_regular: the Lid – print-in-place (default and recommended)
-
Lid_seperated_1_regular and Lid_seperated_2_regular: Both parts separated – print them this way if your printer tends to mess up gaps - to join them just bend the ring a little and insert the lid
Size default assembled: 210 x 192 x 255 mm Volume default: 5 Liters
B: Small
- Body_small: The body
- Lid_small: the Lid – print-in-place (default and recommended)
- Lid_seperated_1_small and - Lid_seperated_2_small: Both parts separated – print them this way if your printer tends to mess up gaps - to join them just bend the ring a little and insert the lid
Size assembled ca: 138 x 120 x 163 mm Volume: 1 Liter
Instructions weighted version
- Get 33 pieces of 1/4 Oz adhesive backed wheel weights in the size 16.4 x 19.3 x 3.7 mm
- Slice the file and check the layer height of the last layer before the bridging over the hollow cutouts starts. Implement a pause after that layer with your slicer.
- Start the print
- At the pause insert the weights and continue printing.
This is the V2
Print settings Material usage regular: Body 180g; Lid 150g Print time regular: Body 18h; Lid 13h
Material usage small: Body 70g; Lid 80g Print time small: Body 6h; Lid 6h
Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 20% Build plate adhesion type: none