Fruit bowl “Wind”

A big and unique fruit bowl made from 3d printed parts and commercially usual wooden skewers.

Instructions (go along with the images)

• Print the base, 44 of the connectors_up and 44 of the connectors_down
• Buy a pack of 100 wooden skewers (you can get them for a few bucks in most supermarkets or online; you only need 88 but you may break one or two during the assembly) Size: 200mm x 3mm
• Start the assembly: begin pushing in the skewers with the flat end into the base on the LEFT next to the cut out Push in all the skewers and add the connectors counterclockwise ( _up for the upper part; _down for the bottom part)
• Push the last skewer into the connectors and bend it a little into the cut out.
• Repeat for the other part
• Enjoy!

Size assembled: 400 x 400 x 334 mm

Print settings Required build volume: 140 x 140 x 40 mm Material usage overall: 270g Print time overall. 29h

Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 10% Build plate adhesion type: none