Snap Close Connector

2.4K downloads · 5 years ago · **Model** Snap close connector that's great for holding small items or fidgeting with. Do not use

Description

Model Snap close connector that's great for holding small items or fidgeting with.

Do not use one of these to hold any sort of load or in a situation that could injure you or someone else.

Build Video

Print Settings Nothing fancy here. Just regular 0.2 mm layer height and minimum 15% infill.

Hardware Required

3 x M3 x 14 mm screws
3 x M3 washers
50 mm paperclip

Other Info I've added 'Type 2' sides that are thinner at the rear and allow the connectors to connect to each other. Unlike the original model, the Type 2 model does require supports though - take your pick between the two.

Check out Scrath's version of this design that also uses nuts

More Electrosync YouTube Instagram Website

Discussions

Mono5 years ago

I wanted to confirm if Connector Side 1, center hole was the correct size. It seems larger than the left and right screw holes. Left and right holes are able to hold the M3 screw but the center hole seems a bit larger.

electrosync5 years ago

Good pick-up. I've updated the files. Thanks!

dan.ballarin5 years ago

I used the wire from a binder clip, bent the wires 90 degrees, and it worked great! Thanks for the file!

dan.ballarin4 years ago

Sorry, I couldn't find it for a while because I moved. It's 1.25 inches long, could squeeze almost 0.5 inches if maxed out. I had to snip the ends a little shorter with wire cutters. It is really addictive to play with.

SinKiller Nick5 years ago

What size binder clip? Thanks.

electrosync5 years ago

Brilliant idea!