Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4602030.

## TS100 Iron Holder for Weller WLC100
***
### __Usage__

This soldering iron holder is meant to attach to the Weller WLC100 soldering station by clipping over the right side at the front and then sliding back to the desired position.

It is designed for the TS100 soldering iron, but should work for any iron less than 5.5mm in diameter and less than 63mm in length. 

The design features internal ribs which prevent the TS100 tip from touching the bottom or sides - this may or may not work for other irons.

Be careful to let the iron cool down before placing it in the holder if not using a high-temperature resin or filament.


### __Printing__

This model was designed to be printed on an AnyCubic Photon, and should be printable without supports or rafts in vertical orientation on any UV resin 3D printer.

Be careful when removing it from the bed - the lower foot has to be very thin to fit under the WLC100 base.

It was not designed for nor tested on FDM printers; results may vary.


### __Notes__

Unfortunately the original design files for this project were lost, so only the STL is available.

***

TS100 Iron Holder for Weller WLC100

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5327332.

ESP32 Case with Snappable Lid

This case is designed to hold an ESP32 board as well as a standard female barrel plug to screw-terminal adapter. There is some room for additional wiring inside as well as an opening for connectors / cables. One version of the lid includes a viewing window so that the LEDs on the board can be seen. Printable windows are also provided - these can be printed in a transparent filament so that the LEDs glow through.

All parts are designed to be a tight fit and may require some tweaking for your particular printer. Snap lids are designed for one-time use but they can be opened and closed multiple times if you are careful. 

ESP32 DevKit V1 Case with Snappable Lid / Barrel Plug Cutout

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

layne.bernardo

TS100 Iron Holder for Weller WLC100

ESP32 DevKit V1 Case with Snappable Lid / Barrel Plug Cutout