2D3D
Makes
Be the first to upload a make
This model is restricted by licensing terms.
View license.
0 Likes5 DownloadsOctober 18, 2021
This model is restricted by licensing terms.
View license.
Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4879047.
This was made to mount a post/pole to the side of something. I used it to mount my weather station (AcuRite 01536) to a fence. The diameter of the pole I used was 26mm. Because I knew it was going to take a ton of plastic and I didn't want to risk it not fitting and having to re-print it, I made the hole diameter 28mm. It doesn't matter if it's a bit loose, as the screw in the center keeps the pole from rotating or moving around too much. I made this because the mount that came with the weather station would not accomodate the pole I chose, even though it DID fit in the bottom of the weather station.
0 Likes5 DownloadsOctober 18, 2021
This model is restricted by licensing terms.
View license.
0 Likes5 DownloadsOctober 18, 2021
This model is restricted by licensing terms.
View license.