White Tiger - Hueforge Print

A beautiful hueforge print of a tiger in black and white. An AMS or MMU is not required, however will make the filament swapping a lot easier!

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

Filaments Used:

• PLA Siddament Black Transmission Distance: 0.2
• PLA+ Sunlu Grey Transmission Distance: 1.4
• PLA Overture Light Grey Transmission Distance: 1.6
• PLA META Sunlu White Transmission Distance: 9.6

Swap Instructions:

• Start with Black
• At layer #11 (1mm) swap to Grey
• At layer #15 (1.32mm) swap to Light Grey
• At layer #18 (1.56mm) swap to White for the rest.