Taylor Swift The Eras Tour Poster - Hueforge Wall Mountable Frame Compatible

Taylor Swift's Eras Tour movie poster. Lots of filament swaps for this one, best to use an AMS (2 for most convenience!)

Note: An AMS is not required, however will definitely make it a lot easier, since this one utilises so many colours! Without an AMS, just insert a ‘Pause’ at the layer height, and then manually unload and load a new filament colour, then resume the print. If you only have one AMS, you can take out a spool that has already printed and replace it with a next colour in line. In the slicer, just assign the colours to the slots accordingly!

This print uses a vectorised version of the poster, so the colours are separated very well for a more ‘abstract effect’. Feel free to swap out the colours for any others that you may prefer!

Filament Swaps:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4

• PLA+ Sunlu Red Transmission Distance: 6

• PLA Sunlu Lilac Transmission Distance: 6.6

• PLA Overture Cream Transmission Distance: 8.4

• PLA Sunlu Beige Transmission Distance: 8.2

• PLA eSUN PLA Matte Light Pink Transmission Distance: 2.8

• PLA Kingroon White Transmission Distance: 8

Swap Instructions:

• Start with Black
• At layer #12 (1.08mm) swap to Red
• At layer #19 (1.64mm) swap to Lilac
• At layer #22 (1.88mm) swap to Cream
• At layer #27 (2.28mm) swap to Beige
• At layer #30 (2.52mm) swap to Light Pink
• At layer #31 (2.6mm) swap to White for the rest.

If you like my models and would like to support my 3D printing endeavours, I now have a Patreon!

Subscribing to the $10AUD tier will grant you a commercial license to sell the physical prints of any of my models.