Scarecrow in a Hat

Can a scarecrow be cute? This one can! I used an orange-yellow hue for this print, but it also looks good in black, blue-gray hue too!

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4
• PLA Overture Orange Transmission Distance: 8.4
• PLA CC3D Lemon Yellow Transmission Distance: 8
• PLA Kingroon White Transmission Distance: 8

Swap Instructions:

• Start with Black
• At layer #14 (0.72mm) swap to Cream
• At layer #23 (1.08mm) swap to Lemon Yellow
• At layer #43 (1.88mm) swap to White for the rest.