The new HueForge 0.7.0 that's currently in beta testing now allows for colour pop images such as this one. And now you get to print it too - even if you don't have 0.7.0 🙂

3MF has everything you need to print it through Bambu Studio, including the layer swaps, and as usual, if you do not use Bambu studio, the STL is there for you. The instructions are below:

Print Instructions Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

Filaments Used:

• PLA Black Transmission Distance: 0.3
• PLA+ eSun Grey Transmission Distance: 1.4
• PLA BambuLab Basic Jade White Transmission Distance: 5
• PLA Kingroon Black Transmission Distance: 0.4
• PLA BambuLab Basic Red Transmission Distance: 5

Swap Instructions:

• Start with Black
• At layer #7 (0.64mm) swap to Grey
• At layer #9 (0.8mm) swap to Jade White
• At layer #13 (1.12mm) swap to Black
• At layer #16 (1.36mm) swap to Red for the rest.

If you'd like my work and would like to support me, you can now subscribe to a Thangs membership plan!

Joining will give you access to a private discord, all paid models, early access to some models as well as a commercial license to sell the physical prints of my models.

If a Thangs Membership is not your thing, I also have a Patreon that gives you the same perks!