I was commissioned to HueForge everyone's favourite Space Princess, and have been given permission to share this with the public!

This is a long print, of nearly 8 hours and uses a total of 8 filaments. So. Be warned! Lol... The 3MF provided will already have all the layer swaps and height range modifiers applied to it for all Bambu Studio users. For non-Bambu users, I have included the STL.

If you use the STL, please follow the instructions below:

Print Instructions: Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm

Filaments Used:

• PLA Kingropm Black Transmission Distance: 0.3
• PLA Chrominal Penumbra Gray Transmission Distance: 6.9
• PLA TECOR Beige Transmission Distance: 6.3
• PLA BambuLab Tough Vermilion Red Transmission Distance: 3
• PLA TECOR Light Blue Transmission Distance: 3.5
• PLA CC3D Lemon Yellow Transmission Distance: 6.8
• PLA PolyTerra Pastel Peanut Transmission Distance: 0.5
• PLA Kingroon White Transmission Distance: 5.8

This print uses 8 unique filaments

Swap Instructions:

• Start with Black
• At layer #8 (0.48mm) swap to Penumbra Gray
• At layer #10 (0.56mm) swap to Beige
• At layer #12 (0.64mm) swap to Vermilion Red
• At layer #16 (0.8mm) swap to Light Blue
• At layer #23 (1.08mm) swap to Lemon Yellow
• At layer #32 (1.44mm) swap to Pastel Peanut
• At layer #38 (1.68mm) swap to White for the rest.

If you'd like my work and would like to support me, you can now subscribe to a Thangs membership plan!

Joining will give you access to a private discord, all paid models, early access to some models as well as a commercial license to sell the physical prints of my models.