One more print inspired by When the Moon Hatched!
Really easy print, honestly, although it does take about 7 hours.
Two colour changes (if you want), black for the base and any sort of moon/light colour for the moon. I used Bambu Lab's beige for this and without being lit up, it's looks very moon like.
The LED light is the flat circular puck from Bambu Lab from the Lamp Kit 001. However, here's a tip - there are the exact same LED kits on Aliexpress for like 50% of the price and you can buy it in bulk too.
They just fit into the hole in the bottom, I used some super glue to hold it in place.
Recommended Settings:
- 0.2mm layer height
- 5 walls, 5 tops, 3 bottoms
- 15% infill cross hatch
- Black for the base up until layer 15, if you don't decide to paint the model (I did!)
Happy printing!!!
Categories:
3 Likes3 DownloadsJuly 20, 2024