House of Earth and Blood - HueForge Book Cover Print

A HueForged cover of the first instalment of the Crescent City series by Sarah J Maas! Put it on your wall, display it on your shelves, all without having to find the room for an actual book.

Prints in about 5-6 hours on a Bambu P1P. The 3MF will have all settings already loaded for Bambu Studio. Otherwise, use the STL and the print instructions below :)

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4
• PLA BambuLab Basic Red Transmission Distance: 5
• PLA CC3D Lemon Yellow Transmission Distance: 8
• PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:

• Start with Black
• At layer #15 (0.76mm) swap to Red
• At layer #25 (1.16mm) swap to Lemon Yellow
• At layer #37 (1.64mm) swap to Jade White for the rest.

If you'd like to support me, you can now subscribe to a Thangs membership plan!

Joining will give you access to a private discord, all paid models, as well as a commercial license to sell the physical prints of my models.

If a Thangs Membership is not your thing, I also have a Patreon with the same perks!