[This is an Early Access file that will be made available to the public at a later date, and is exclusively for subscribers for now!]

I'm adding to my 'Retro Gaming' series with this classic and I hope you find some joy in it!

This is a 7 filament print, so probably best if you have 2 AMS to do this, otherwise be prepared for some babysitting and manual swaps! If you have a low TD Matte Pink, I would highly suggest using that too, as an accent to the Christmas ornament on the print.

Print Instructions Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm

You may print at higher layer heights below the Min Depth of 0.4mm

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.2
• PLA BambuLab Matte Dark Red Transmission Distance: 1.5
• PLA CC3D Lemon Yellow Transmission Distance: 6.8
• PLA Chrominal Chestnut Brown Transmission Distance: 3.5
• PLA BambuLab Basic BambuLab Green Transmission Distance: 2
• PLA eSUN PLA Matte Light Pink Transmission Distance: 2.8
• PLA Kingroon White Transmission Distance: 5.8 This print uses 7 unique filaments

Swap Instructions:

• Start with Black
• At layer #13 (0.68mm) swap to Dark Red
• At layer #17 (0.84mm) swap to Lemon Yellow
• At layer #22 (1.04mm) swap to Chestnut Brown
• At layer #29 (1.32mm) swap to BambuLab Green
• At layer #34 (1.52mm) swap to Light Pink
• At layer #41 (1.8mm) swap to White for the rest.

If you'd like my work and would like to support me, you can now subscribe to a Thangs membership plan!, or if you prefer, my Patreon.

Joining will give you access to a private discord, all paid models, early access to some models as well as a commercial license to sell the physical prints of my models.