CR-6 SE filament runout sensor adapter for Direct Drive LGX Extruder

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4940507.

This runout sensor holder for the CR-6 SE is designed to connect to the LGX Bondtech Direct Drive setup that connects the PTFE tube from the hotend to the runout sensor and then up to a top mounted spool. This uses two PC4-M6 pneumatic fittings.

It's a little odd as it fits front to back rather than left to right. This is to cater for the cables and reverse bowden tube coming from in front of the gantry to the left hand side (see photo).

Probably best printed in PLA for durability.

Additional components:

2 x PC4-M6 pneumatic fitting 2 x M3x8mm screws to attach the housing to the printer

No supports are needed.