Upload for Search
Search By Text
Upload for Search
Search By Text
JM

CR-6 SE Filament guide for top mounted spool holder

by

chirpy

Follow
Follow
Remix Model
Like
CR-6 SE Filament guide for top mounted spool holder by chirpy full viewable 3d model
Loading preview...
0 Likes1 DownloadsNovember 21, 2021

This model is restricted by licensing terms. 

Community Uploads

No photos added yet, be the first to upload a photo!

This model is restricted by licensing terms. 

0 Likes1 DownloadsNovember 21, 2021

Community Uploads

No photos added yet, be the first to upload a photo!

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4921536.

2021-08-03 - Improved the bottom part

Designed for the CR-6 SE, this helps guide the filament from a top mounted spool holder down to the runout sensor.

The bottom part fits over the filament runout sensor. The top part snaps onto the top left of the gantry structure.

PLA is fine as there's no stress on the parts.

Additional hardware:

2 x PC4-M6 pneumatic fittings, one for each part.

Be careful to have your x axis at bed level before cutting tubing to fit as it will have to extend that far as the gantry moves.

It's best not to use clips on either pneumatic fitting.

Because of the extra length of tubing needed, it does make it trickier to load the filament, but you can always pop out the tube by the runout sensor and push the filament through and then reattach.





0 Likes1 DownloadsNovember 21, 2021

This model is restricted by licensing terms. 

Community Uploads

No photos added yet, be the first to upload a photo!

This model is restricted by licensing terms. 

0 Likes1 DownloadsNovember 21, 2021

Community Uploads

No photos added yet, be the first to upload a photo!