Colby G

Auto Locking Guitar Holder

by
ForgeCore
Follow
Follow
Remix Model
bjacobs0507
bjacobs0507
|
|
Image 12 of 12
Auto Locking Guitar Holder - Such a greatly designed model would recommend  - 3d model
bjacobs0507
bjacobs0507
|
|
Image 12 of 12
Auto Locking Guitar Holder - Such a greatly designed model would recommend  - 3d model
2D
3D
Makes
Auto Locking Guitar Holder 3d model
Auto Locking Guitar Holder 3d model
Auto Locking Guitar Holder 3d model
Auto Locking Guitar Holder 3d model
Auto Locking Guitar Holder 3d model
Auto Locking Guitar Holder 3d model
Auto Locking Guitar Holder 3d model
Auto Locking Guitar Holder 3d model
Auto Locking Guitar Holder - Made with Bambu PLA-CF - 3d model
Auto Locking Guitar Holder 3d model
Auto Locking Guitar Holder - There seems to be a problem with the model upon slicing. there are holes at the rear part of the base - 3d model
Auto Locking Guitar Holder - Such a greatly designed model would recommend  - 3d model

Don't have a 3D Printer? My models print great with These Printers (affiliate)


Auto Locking Guitar Holder

This guitar holder automatically opens and closes top keep your guitar from falling off the wall. It works great to display your guitar, but the best part is that its satisfying to use.

Its works via a linear gear system and a rubberband that resets the guards when the guitar is off the wall. You will need a single standard rubber band to make this. A little bit of vaseline or lubricant makes it function even smoother.

Filament I Used: Matte Green

Components Rubber Band

Assembly Watch This video!

  1. Slot Levers into base

  2. Insert left and right hooks onto levers. The levers should be oriented straight up when placing the hooks on.

  3. Lock the hooks into place by screwing on the locking caps onto the threaded part of the levers

  4. Orient Levers up, and insert a bumper into each side. Make sure the teeth on the bumper face inward, and the grooves are facing outward. You will need to press hard to get them inserted.

  5. Tie a knot in the middle of a rubber band. Wrap one loop of the rubber band on each of the hooks. The mechanism should now work

  6. Install onto wall by placing the base into the wall bracket and screwing into the wall.


730 Likes1.2K DownloadsApril 18, 2024


730 Likes1.2K DownloadsApril 18, 2024