Optigon 2 HMD Frame: Moverio BT-40 Mod

This kit helps you turn an Epson Moverio BT-40 into the Optigon 2 Head-Mounted Display, a discreet, unobstructive monocular wearable HUD.

1. Print one copy of each part in a relatively stiff filament.
2. Cut the Moverio's ribbon cable at the base of the left lens. Peel the cable and protective decal off the lens.
3. Slice your Moverio's right display off and polish the edge. I strongly recommend covering the lens with masking tape to protect it from scratches.
4. Attach the Frame to the top of the left lens using carpet tape or E-6000.
5. Using screws from the removed right half, attach the Arm and use the Bridge Clamp to secure the Moverio's nose bridge.
6. Fabricate, assemble, and install the Optigon Modchip: https://a360.co/3eBTL5L

⚠ CRITICAL WARNING!! ⚠ Once a display is disconnected, the BT-40 will shut itself off every few seconds. You must fabricate and install an Optigon Modchip between the lapel board and headset cable. This is a very difficult board to solder and not recommended for beginners.

Parts: 🥽 Epson Moverio BT-40: https://amzn.to/3RUvghW 🔌 Mezzanine connectors: Socket: JAE 656-WP27DS030VA3R15K https://www.mouser.com/ProductDetail/656-WP27DS030VA3R15K Plug: JAE 656-WP27DP030VA3R15K https://www.mouser.com/ProductDetail/656-WP27DP030VA3R15K