tracking pixel
ZFamilyRC

Flite Test FT Mini Arrow Fuselage w Parts

by
ZFamilyRC
Follow
Follow
Remix Model
ZFamilyRC
ZFamilyRC
Image 1 of 3
Flite Test FT Mini Arrow Fuselage w Parts  3d model
2D
3D
Makes
Flite Test FT Mini Arrow Fuselage w Parts  3d model
Flite Test FT Mini Arrow Fuselage w Parts  3d model
Flite Test FT Mini Arrow Fuselage w Parts  3d model
2 Likes3 DownloadsMay 26, 2024


FT Mighty Mini Arrow PLA or PETG ( is what I use ) Firewalls - No Supports - Note different screw mounting spacing is different for different motors. The A Motor and F Motor applies to the motors sold by https://store.flitetest.com/ Rear Spacer - No Supports Hatch - Support only under the tab, not needed for the magnet holder ( I don't use a magnet, I simply apply a piece of masking tap to the hatch just before flight ) Pod - I print upside down and Do Not use supports for the Nose or other "above the build plate". I do use supports for the rest of the "touching build plate".

INSPIRATION The Pod is a Remix from https://www.thingiverse.com/thing:1972543 The Hatch is from the same The Rear Spacer is from https://www.thingiverse.com/thing:3033273 The Firewalls are my original


2 Likes3 DownloadsMay 26, 2024





2 Likes3 DownloadsMay 26, 2024