tracking pixel
W

Stepcraft cablechain modification

by

WalterSKW

Follow
Follow
Remix Model
Like
Stepcraft cablechain modification 3d model
2D
3D
Makes
Be the first to upload a make
This model is restricted by licensing terms. 
0 Likes1 DownloadsOctober 16, 2021
This model is restricted by licensing terms. 


Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3129143.

I had a Z-stepper wire broken at the connection part down on the left-Y bracket. So I decided to rewire the whole thing and to install a cablechain.

I reused a cablechain I had (similar to this one) The cablechain runs on a Alu 20x20 L-profile supported by 2 printed supports ('front support' and 'back support' items). These supports are mounted using one M3 screw and have a tight fit. I used a 12 wire Lapp-cable with 0,5mm (numbered) wires. 1 to 4 are X-stepper, 5 to 8 are Z-stepper, 9 and 10 are endstop switches for X and Z and 11 and 12 are for the LED-strip. The cable comes from Conrad

I reused the cable protection from the cabling under the bed to the controller board (13mm dia) and installed that on the X-axis. The parts 'locking x-rail' and 'x-rail' fit in the top slot of the X -axis.

The 'cable cover part' clicks on the Y-support bracket and covers the cableconnections.

See also this video


0 Likes1 DownloadsOctober 16, 2021




This model is restricted by licensing terms. 
0 Likes1 DownloadsOctober 16, 2021
This model is restricted by licensing terms.