Squid Game - Front Man Mask

I attempted to make this mask as 'show-accurate' as possible, although i'm sure there's still room for improvement so I may revisit it in the future! The mask was designed to print best oriented upside down, and will need supports to hold it up and in the eyes! I have included photos of how to best deal with the supports. The mask fits my face perfectly with a little bit of room to spare. You can always scale up or down, or use a heat gun to make minor adjustments if needed! The 'grates' for the eyes print separately flat on the build plate, I figured this was the best way to make them look great. Printing, Assembly & Post Processing

• The mask prints best upside down (should already be oriented that way) with supports underneath and in the eyes. Please see the photos in the main folder for a snapshot of how I did my supports.
• The strap slots DO NOT need support if you keep the mask oriented the way it is (they will bridge), so make sure and block supports there if you want a clean bridge. If you have to rotate the mask to fit your build plate they may need supports.
• The eye 'grates' print separately, flat on the build plate, and need to be glued into place afterwards.
• The strap slots are big enough to accomdate a 1". I used a stretchy strap I found on Amazon!

FDM or Resin: FDM, or large format resin. Not much detail though, so no real need for resin. Scaling: Current size is 155 x 91 x 222
Supports: One the bottom and in the eyes. I also used a raft to help improve adhesion. Nozzle Size I Used: 0.6 **Infill/Perimeters:**I used 15% with 2 perimeters Layer Height: I used 0.30 and it turned out well, but finer layer height will look better depending on your print quality and filament.

**This design is uploaded with a non-commercial license. Purchasing this file does not grant you the rights to sell commercially.

If you would like to consider gaining access to ALL of the models and the rights to print and sell, you can check out my Patreon at https://www.patreon.com/thinair3D