Printing, Assembly & Post Processing
FDM or Resin: Either (I've only printed FDM so far) Scaling: All Low Poly Pokemon are currently at the smallest scale I like to FDM print them at, but you can scale up or down in the slicer as you please and they should be fine. Supports: None Nozzle Size I Used: 0.6 Infill/Perimeters: Your preference, but since they are decorative you would be good with very little. Layer Height: I printed with 0.6 mm with no issues, any large might cause problems on the thinner parts.
Post-Processing/Assembly: None needed, but you can if you want. I could see painting they eyes black might look nice.
**This design is uploaded with a non-commercial license. Purchasing this file does not grant you the rights to sell commercially.
If you would like to consider gaining access to ALL of the models and the rights to print and sell, you can check out my Patreon at https://www.patreon.com/thinair3D