tracking pixel
Jacob P

Low Poly Oddish

by

ThinAir3D

Follow
Follow
Remix Model
Like
ThinAir3D
ThinAir3D
Image 1 of 2
Low Poly Oddish 3d model
2D
3D
Makes
Low Poly Oddish 3d model
Low Poly Oddish 3d model
18 Likes87 DownloadsMarch 6, 2022


Printing, Assembly & Post Processing

FDM or Resin: Either (I've only printed FDM so far) Scaling: All Low Poly Pokemon are currently at the smallest scale I like to FDM print them at, but you can scale up or down in the slicer as you please and they should be fine. Supports: None Nozzle Size I Used: 0.6 Infill/Perimeters: Your preference, but since they are decorative you would be good with very little. Layer Height: I printed with 0.6 mm with no issues, any large might cause problems on the thinner parts.

Post-Processing/Assembly: None needed, but you can if you want. I could see painting they eyes black might look nice.

**This design is uploaded with a non-commercial license. Purchasing this file does not grant you the rights to sell commercially.

If you would like to consider gaining access to ALL of the models and the rights to print and sell, you can check out my Patreon at https://www.patreon.com/thinair3D


18 Likes87 DownloadsMarch 6, 2022




18 Likes87 DownloadsMarch 6, 2022