tracking pixel
TheNeverCat

Glovebox mending plate for Chevy GM C K 1500.

by
TheNevercat
Follow
Follow
Remix Model
Glovebox mending plate for Chevy GM C K 1500. 3d model
2D
3D
Makes
Be the first to upload a make
1 Likes1 DownloadsJune 30, 2022


A replacement for the right side hook. print the hook. place it where the inner plastic meets the outer and mark your cut lines. -Dremel cut (not too deep) and remove the excess plastic (remember better to under cut and adjust than over cut) -Place it and use the screw to set the placement. -Use a scrap soldering iron to plastic weld the piece in place.

  • The tolerance is a bit tighter than stock so be sure to reach in and carefully place the hook around the dowel (should be a light click)

Tags:


1 Likes1 DownloadsJune 30, 2022




1 Likes1 DownloadsJune 30, 2022