Introducing my third artful shadow box using Hueforge, the filament painting software.

It's a reproduction of "The Starry Night" by Vincent van Gogh.

Van Gogh was seeking respite from plaguing depression at the Saint-Paul asylum in Saint-Rémy in southern France when he painted The Starry Night. It reflects his direct observations of his view of the countryside from his window as well as the memories and emotions this view evoked in him.

I've used the following colors:

Plate 1

• Start with Sunlu PLA Black
• At layer #4 (0.40mm) swap to Fillamentum ExtraFill PLA Cobalt Blue
• At layer #5 (0.48mm) swap to Fillamentum ExtraFill PLA Traffic Yellow
• At layer #8 (0.72mm) swap to Fillamentum ExtraFill PLA Purple Red for the rest.

Plate 2

• Start with Sunlu PLA Black
• At layer #5 (0.48mm) swap to Fillamentum ExtraFill PLA Wizard's Voodoo
• At layer #9 (0.80mm) swap to Fillamentum ExtraFill PLA Baby Blue
• At layer #11 (0.96mm) swap to Fillamentum ExtraFill PLA Sky Blue
• At layer #17 (1.44mm) swap to Fillamentum ExtraFill PLA Traffic Yellow
• At layer #20 (1.68mm) swap to Fillamentum ExtraFill PLA Traffic Red for the rest.

Plate 3

• Start with Sunlu PLA Black
• At layer #4 (0.40mm) swap to Fillamentum ExtraFill PLA Cobalt Blue
• At layer #8 (0.72mm) swap to Fillamentum ExtraFill PLA Sky Blue
• At layer #13 (1.12mm) swap to Fillamentum ExtraFill PLA Traffic Yellow
• At layer #17 (1.44mm) swap to Fillamentum ExtraFill PLA Traffic Red for the rest.

Plate 4

• Start with Sunlu PLA Black
• At layer #4 (0.40mm) swap to Fillamentum ExtraFill PLA Cobalt Blue
• At layer #9 (0.80mm) swap to Fillamentum ExtraFill PLA Sky Blue
• At layer #13 (1.12mm) swap to Fillamentum ExtraFill PLA Baby Blue
• At layer #19 (1.60mm) swap to Fillamentum ExtraFill PLA Orange Orange
• At layer #20 (1.68mm) swap to Fillamentum ExtraFill PLA Traffic Yellow for the rest.

It consists of 4 numbered plates.

You can find the box to display this set here

The box with lid and the wall mountable box are both Club member exclusives. (Box with lid also available for individual purchase on Cults3D)

Try to match the colors as good as possible if you don't have the filaments I've used.

Since these are rather complex STL files, slicing can take a while. Some of the STL files may report an error, please do not fix them! You will lose details if you do. The errors are a result of the complex STL file Hueforge produces.

Print settings

• Layer height of 0.08mm with a base layer of 0.16mm
• No supports
• 100% infill
• The STL's contain a very thin layer where the empty space should be. This is an artefact that Hueforge leaves in the STL. The slicer will ignore it when slicing.

ALL The Crafty Maker designs are protected by Copyright Law. By downloading, YOU HAVE NO RIGHT to sell any digital files or reproductions from those files. If you want a commercial license to LEGALLY SELL 3D prints, you'll need a The Crafty Companion subscription.