tracking pixel
The-EG

Pin-Lock Keg Post Wrench

by
The-EG
Follow
Follow
Remix Model
Pin-Lock Keg Post Wrench 3d model
2D
3D
Makes
Be the first to upload a make
This model is restricted by licensing terms. 
0 Likes2 DownloadsOctober 18, 2021
This model is restricted by licensing terms. 


Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4566473.

This is a wrench for removing and tightening the posts on a pin-lock ('corny' or cornelius style) 5 gallon keg.

The posts normally require a 13/16" socket with either 2 (gas) or 3 (liquid) slots cut out for the pins. This fits both gas and liquid posts.

If you've purchased a used keg and need to remove the posts for the first time, you will need a metal socket on a ratchet with a long handle, since those kegs usually have blown o-rings and the posts have been way over tightened to compensate.

But otherwise, this will work well for removing and tightening posts on kegs with good o-rings. If you tighten your posts down hard enough to break this tool, you will destroy your o-rings. If your keg won't hold pressure without them being tightened that far, you already have!


0 Likes2 DownloadsOctober 18, 2021




This model is restricted by licensing terms. 
0 Likes2 DownloadsOctober 18, 2021
This model is restricted by licensing terms.