tracking pixel
The-EG

Hydra Fan Duct - 5015 35deg ducts with no 'bump'

by
The-EG
Follow
Follow
Remix Model
Hydra Fan Duct - 5015 35deg ducts with no 'bump' 3d model
2D
3D
Makes
Be the first to upload a make
This model is restricted by licensing terms. 
0 Likes3 DownloadsOctober 18, 2021
This model is restricted by licensing terms. 


Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4674660.

These are BoothyBoothy's 5015 35 deg fan ducts for the Hydra, but with the 'bump' on the inside removed.

See my comment here: https://www.thingiverse.com/thing:4062242/comments#comment-4098757

I found that bump was causing the ducts to warp (PLA) or crack (ABS) due to the stress it was putting on the very thin wall opposite. And, the fan fits very well without it, so it doesn't seem to be needed at all.

Print with supports from bed only, the same as the original fan ducts.


0 Likes3 DownloadsOctober 18, 2021




This model is restricted by licensing terms. 
0 Likes3 DownloadsOctober 18, 2021
This model is restricted by licensing terms.