These are a set of bins I designed specifically for a built-in in my apartment. This one measures 4 inches wide by 5 inches deep by 9 inches (ish) tall (sorry for the units my EU friends).

After 8 iterations, redesigns and reprints, I've found PETG performs best with this particular model. PLA works, however I usually had a lot of cleanup on the stringing in the hexes afterwards, whereas PETG @ 230c and 150 mm/s worked nearly flawlessly without any stringing. Please comment your successful settings though as I am still having trouble getting the floor of the bin to print without blistering when using Concentric patterns or the like.

Designed in Tinkercad, the hex pattern is a repeating pattern trimmed on the edges, so re-sizing to whatever dimensions you need should be pretty simple, but message me if you need a particular set of dimensions and I might take a crack at it if I have time. Tinkercad file below to remix with if you want: https://www.tinkercad.com/things/hZ36bubRkEJ?sharecode=ZK1efOMKQ0vd52pIDA50fgz2jkDBfDEKqysG56LNbEQ

8" Version "B" https://social.thangs.com/m/649379