small version Trex skull wall mount or PC mod
bySparkPrinting3DThis comes will the starter pack for joining on thangs on any member Tier
No supports, No glue, This comes will the starter pack for joining on thangs
NOTE high retractions could cause problems with the teeth, especially if your printing very fast. This goes for both trex and raptor skulls I'd recommend not going over 80mm per second when it starts the teeth but this may very based on how good your printer is. you might have to printer much slower if your print has problems with retractions.
Agreement and Liability Disclaimer: By downloading and using this file, you agree to the following terms: You understand and acknowledge that SparkPrinting3D is not responsible for any injuries, damages, or losses that may occur from the use or misuse of this file or the resulting 3D printed product. You assume full responsibility for the safe handling, assembly, and use of the product.
The hardware you will need for mounting on the wall is Safety Glasses, glove, long sleeve shirt, pants, shoes, bit adjustable screwdriver with a bit extender , Allen key and or hex bit set 2mm 2.5mm 3mm 3.5mm 4mm, 2 M4 15mm bolts to mount to the backboard and two #6 1iches to mount the backboard to the wall.
The hardware you will need to mount to the PC case is Safety Glasses, glove, long sleeve shirt, pants, shoes, bit adjustable screwdriver with a bit extender , Allen key and or hex bit set 2mm 2.5mm 3mm 3.5mm 4mm, 2 M4 15mm bolts to mount the mod to the skull and 4 M3 10mm bolts to mount the mod to the PC case.
Safety and Usage Disclaimer for the PC use : This 3D printed dinosaur skull is not a toy and is not intended for children.Recommended for ages 14 and up.Keep out of reach of children.The skull contains sharp parts, including teeth, that may pose a hazard.Use safety glasses, gloves, and proper tools when installing or removing the skull.Ensure the computer is unplugged before installation or removal to avoid electrical hazards.Remove the dinosaur skull before moving the computer to prevent damage or injury.The creator assumes no responsibility for any damage to the PC or injuries resulting from the installation, use, or removal of this model.
Safety and Usage Disclaimer for the wall mount use:
These 3D printed models are not toys and are not intended for children. Choking Hazard: The models contain small, intricate parts that may pose a choking hazard. Keep out of reach of children and pets. Recommended for ages 14 and up. When assembling you should not stand directly underneath the 3D printed parts when putting it on the wall you should be at least 18 inches from the wall so it can't fall on you. Models may contain sharp and pointy parts, such as ribs, teeth, and claws. Use safety glasses, gloves, long sleeves, and proper footwear shoes when assembling. Do not place in high-traffic areas, such as hallways, or areas where people walk directly underneath.Avoid placing behind couches or other seating areas where falls could cause injury. The creator assumes no responsibility for injuries or damages resulting from the use or misuse of these models.This includes damages to property, such as televisions or other items, that may occur if the model falls. Also in addition during the assembly process 3D printed parts should be placed in a box or out of the way where they are not on the floor where anyone can trip on them step on them or fall on them this could cause serious injury SparkPrinting3D Will not be held responsible or liable for any damages or injuries occurred during the assembling process.