You get 2 versions 1 for single color stl and the duel color 3mf also part of the starter pack.
This model requires good tuning from your printer to have the jaw open and close.
Print setting Infill I recommend at a minimum of 10% pattern type I use is lines to get best print quality a recommend 0.4 nozzle at 0.2 mm layer height. I recommend at a minimum of 3 perimeters. 4 bottom and top layers. Print speed I'm unfamiliar with the newer printers as mine is the ender 3 so I don't have input shaper. Print at what speed you normal do with models like this. No supports Raft or brim if you have adhesion issues
Agreement and Liability Disclaimer
By downloading and using this file, you agree to the following terms: You understand and acknowledge that SparkPrinting3D is not responsible for any injuries, damages, or losses that may occur from the use or misuse of this file or the resulting 3D printed product. You assume full responsibility for the safe handling and use of the product.
Safety and Usage Disclaimer:
Warning: This model contains very sharp points. This model is therefore unsuitable for children. We also do not recommend purchasing this model if it is intended to be used as a fidget or sensory toy Please note that articulated models are unsuitable for small children, as small pieces may break off from the model and create a potential choking hazard. Sparkprinting3D is not liable for any event(s) following the improper or inappropriate use of its products.