This comes will the starter pack for joining on thangs on any member Tier
Large Spinosaurus foot paper weight for the 400mm bed size No supports, No glue, No paint and No sanding needed.
Printing Instructions: Infill I recommend at a minimum of 10% pattern type I use is lines to get best print quality a recommend 0.4 nozzle at 0.2 mm layer height. I recommend at a minimum of two perimeters. Four bottom and top layers. Print speed I'm unfamiliar with the newer printers as mine is the ender 3 so I don't have input shaper you may want to print slower because its a tall print.
Agreement and Liability Disclaimer
By downloading and using this file, you agree to the following terms: You understand and acknowledge that SparkPrinting3D is not responsible for any injuries, damages, or losses that may occur from the use or misuse of this file or the resulting 3D printed product. You assume full responsibility for the safe handling and use of the product.
Safety and Usage Disclaimer:
Warning: This model contains very sharp points. This model is therefore unsuitable for children. We also do not recommend purchasing this model if it is intended to be used as a fidget or sensory toy Please note that articulated models are unsuitable for small children, as small pieces may break off from the model and create a potential choking hazard. Sparkprinting3D is not liable for any event(s) following the improper or inappropriate use of its products.
These 3D printed dinosaur foot paperweights are not toys and are not intended for children.
Warning: Keep out of reach of children and pets. The paperweights contain sharp and pointy parts, particularly on the skeletal feet.
Caution: Handle with care to avoid injury. The SparkPrinting3D assumes no responsibility for injuries or damages resulting from the use or misuse of these paperweights.