How to make a Cube Lamp

Hey,

this post will provide instructions on how my new Cube Lamp.

For this Lamp, you will need to print out these pieces:

9 normal pieces

3 final Pieces

and the Socket Holder

I'd print the Socket first, then the 3 final Pieces and then the normal Pieces.

All Pieces snap together like in this picture.As you can see, there are these small hooks that snap into holes on the other parts. They print good, but sometimes require a little but of pushing to get together.

Ok so first take the 3 final Pieces. They have a cut-out where the Bulb

is supposed to go.Assemble them like this, leaving one side open. You can orient yourself on the cut-out. It's supposed to form a round Hole. Now Put in the Bulb with the socket holder already assembled.

As you can see, I did already attach some rope tho the socket holder, since that's a little harder to do later.
Now close the side that you left open.
From this point on, just add normal Pieces to the sides of the pieces that were already assembled. There you go, it should eventually become the whole Lamp.

Here is a no there picture of a few assembled pieces that you can use as an orientation.

That's it. Hope you got this together.

Don't hesitate to ask questions. I will also make a Video on this in a few days, btw.

Hope You like your new Lamp!

Have a lovely day,

Ruven