Snowglobe Votive Ornament - Xmas Town
This classic holiday 3D model can be used as a large ornament for your Christmas tree or as a tabletop decoration. The charming glowing Christmas tree in the town square is surrounded by shops. This updated design prints better and has an improved tealight compartment with screw on cap (print separately). Holds tealights up to 40mm in diameter.
Built-in scaffolding supports are to be removed.
Creative Commons License BY-NC-ND 4.0 A commercial license to sell these prints is available by subscribing to my Thangs Commercial Partner membership plan.
Suggested Print Settings – PrusaSlicer Print in place – no supports necessary (organic/tree supports can be used to create a cleaner print) Layer Height: 0.2mm Infill: 8% Gyroid Perimeters: 2 or 3 (2 will make the tealight glow more prominent, 3 should improve the exterior surface quality) Extra Perimeters if Needed: X Extra Perimeters on Overhangs: X Avoid Crossing Curled Overhangs: X Seam Position: Random Enable Dynamic Overhang Speeds: X Adjust Retraction Settings for excessive retractions dependent on filament.