tracking pixel
Project Print Lab

Skateboard Deck Wall Mount with Med. Command Strips

by
ProjectPrintLab
Follow
Follow
Remix Model
ProjectPrintLab
ProjectPrintLab
|
Image 1 of 3
Skateboard Deck Wall Mount with Med. Command Strips 3d model
ProjectPrintLab
ProjectPrintLab
|
Image 1 of 3
Skateboard Deck Wall Mount with Med. Command Strips 3d model
2D
3D
Makes
Skateboard Deck Wall Mount with Med. Command Strips 3d model
Skateboard Deck Wall Mount with Med. Command Strips 3d model
Skateboard Deck Wall Mount with Med. Command Strips 3d model
This model is restricted by licensing terms. 

This skateboard deck display mount

Uses M5 hex nuts that should be heat pressed in for longevity Mount using 25mm M5 screws (or up to 50mm) to thread into the model for additional support Recessed slot on back for a flush wall mounting using medium 12lb. command strips Added a Girl Skateboards logo for fun! No supports needed. Slot bridges fine without.

Remix of model from RaptorRL18


3 Likes16 DownloadsAugust 26, 2024



3 Likes16 DownloadsAugust 26, 2024
This model is restricted by licensing terms. 

Instructions

Filament • 0.2mm

MaterialPLA
Layer height0.2 mm
Infill density15 %
SupportsNone
BrimNo