Skateboard Deck Wall Mount with Med. Command Strips
byProjectPrintLabThis model is restricted by licensing terms.
View license.
2 Likes8 DownloadsAugust 26, 2024
This model is restricted by licensing terms.
View license.
Instructions
Filament • 0.2mm
MaterialPLA
Layer height0.2 mm
Infill density15 %
SupportsNone
BrimNo
This skateboard deck display mount
Uses M5 hex nuts that should be heat pressed in for longevity Mount using 25mm M5 screws (or up to 50mm) to thread into the model for additional support Recessed slot on back for a flush wall mounting using medium 12lb. command strips Added a Girl Skateboards logo for fun! No supports needed. Slot bridges fine without.
Categories:
2 Likes8 DownloadsAugust 26, 2024
This model is restricted by licensing terms.
View license.
2 Likes8 DownloadsAugust 26, 2024
This model is restricted by licensing terms.
View license.
Instructions
Filament • 0.2mm
MaterialPLA
Layer height0.2 mm
Infill density15 %
SupportsNone
BrimNo