DESERT ARTICULATED RATTLESNAKE (1.2 METERS)
byPrintplay3d
DESERT ARTICULATED RATTLESNAKE (1.2 METERS)
Check the mobility out HERE: https://www.instagram.com/p/C9xS7PKtwV7/?hl=en
Drop a follow if you want more content like this one ;)
This is a SUUUPER long and cute desert rattlesnake. As you can see, it can get up to 1.2 m (depending on your slice scale) on a 256x256 mm plate!
The model is amazing and super simple to print. It will be a little challenge for your clearance settings, see if you can print it (it is easy in the end don't worry ;) ).
Buying this model does not grant access to sell it commercially, just for PERSONAL USE!
Any question regarding the model can be sent to my Instagram: https://www.instagram.com/printplay.3d/
YOU FILL FIND THIS MODEL ON MY COMMERCIAL LICENCE MEMBERSHIP. ONLY WHEN THIS MEMBERSHIP IS ACTIVE YOU WILL BE ABLE TO SELL THIS MODEL YOURSELF
3D printing settings MODEL IS SCALABLE but check the slicing before printing to ensure the scale is enough to not fuse the articulations together (can end up happening if you scale down too much)!!
SPEED: I printed this at 50% speed on my printer to ensure the final result was amazing and it worked perfectly. Personally, I would not go too fast due to the high quantity of jumps the printer will have to perform. If you have small extrusion problems it will be visible so keep the speed down for this one!
Layer height: here you have different options, all of them could be used: -0.2 mm for a "not so detailed" final print. Use this only as final resource.
- 0.08 mm for a super detailed final print. This is the one I usually chose. -You could also use the adaptative layer height on BambuStudio to combine the best of both worlds
NO SUPPORTS ARE NEEDED!
Adhesion: I used a brim to prevent Warping but you should be safe without it.
Infill: between 5 - 10% is more than enough.