Start making money by selling 3D printed models. Sign up to the PrintStart3D Thangs Membership to sell my models in your shop and more!

For more content visit me on Instagram: www.instagram.com/PrintStart3D

Thank you so much for the support <3

This is a 3D model of Luke Skywalkers Light Saber. The model comes in 1 piece or in 2 halves to fit on smaller printers. It is scaled to a realistic size. Print the bottom half vertical and the top horizontal(you can try the top vertical, but the supports may be hard to remove) I hope you enjoy this model!

Print with at least 3 walls and at least 25% infill if this will be used as a prop to insure durability. I suggest PLA for this print so it can be easily painted. You can use PETG if you are going to have this in heat for long periods of time, such as cosplay outdoors. It can be printing vertically or horizontally. Horizontal will use less supports and will be a little stronger. Vertically will look nicer and use lots of support, but could be brittle from the layer lines if the print goes bad. Good luck printing!

I greatly appreciate all the support! Thank you so much!