22 Likes38 DownloadsOctober 5, 2024
Instructions
Filament • 0.2mm
MaterialPLA
Layer height0.2 mm
Infill density15 %
SupportsTree
Fascinating Super Mario Bob-Omb soap dispenser that makes your bathroom an eye-catcher. (If you want to know which soap pump I used, do not hesitate to contact me) PS: Super combinable with my Mushroom - Toothbrush Holder. Together, they look bombastic.
- length x width x high= 15 x 14 x 15 cm
- ball diameter= 11cm
- printable in 6 stages with minimal support (thread: blue, body: black, eyes: white, wind-up part: blue, legs: blue, shoe-sole: black)
- plug- in system with tongue and groove
- standard screw cap (28mm)
- for assembly: a little bit of superglue is needed
Categories:
22 Likes38 DownloadsOctober 5, 2024
22 Likes38 DownloadsOctober 5, 2024
Instructions
Filament • 0.2mm
MaterialPLA
Layer height0.2 mm
Infill density15 %
SupportsTree