Fits on the EQ6-r Stock spreader, fits in the two 2" holes for stability, tested on the original spreader (with the high arch) and newer ones with the low arch (2023 model)

The No_support one is flat and relies on the arch to stop it moving - not as stable, but quicker and easier to print, I recommend using the normal one and spending the time to print it with support, it's much better.

Normal one requires a lot of support but is worth it for stability considering what might go into it. Took me 9 hours in ASA, so you can probably do it in 6-7 hours in PLA, My tripod stays out all year though so I just leave it on there and used abs/asa