Horizontal, minimalist, and subtle (unless you print it in bright red of course).

This design is for the original PS5 version with disk. Print 2 long springs and 2 short springs.

Print Recommendations

Print Material: PETG (this design relies on the semi flexible properties of PETG)

Infill Percent: 25%

Perimeters: 3

Layer Height: .3

Supports: NONE

Print orientation: Place each spring sideways against the build plate. Assembly Instructions

Attach double sided tape to each of the 4 springs. With the PS5 standing upright, place the 2 short springs near the base of the console (at each corner) and the 2 longer springs near the top.

Additional Parts Required Double Sided Tape Required

• Amazon Link to 3M .4 inch double sided tape https://a.co/d/3n44GFr

• This adhesive twists off easily and doesn't leave residue.