PS5 Horizontal Stand (for disk version)

Horizontal, minimalist, and subtle (unless you print it in bright red of course).

This design is for the Standard PS5 version with disk. Print 2 long springs and 2 short springs.

Double sided tape is required. See Amazon link below for adhesive which doesn't leave residue, but any double sided tape should work just fine.

Print Recommendations

Print Material: PETG (this design relies on the semi flexible properties of PETG)

Infill Percent: 25%

Perimeters: 3

Layer Height: .3

Supports: NONE

Print orientation: Place each spring sideways against the build plate (refer to Prusa Slicer file for reference)

Assembly:

Attach double sided tape to each of the 4 springs. Place the 2 short springs near the base of the console and the 2 longer springs near the top (see photos for reference).

Double Sided Tape Required

Amazon Link to 3M .4 inch double sided tape https://a.co/d/3n44GFr

This adhesive twists off easily and doesn't leave residue.