Magsafe and Apple Watch Charging Mount (USB-C and USB Versions)

Turns your Magsafe and Apple Watch charger into a dedicated charging station. Fits only official Apple products.

There are 2 models. One for USB-C Apple Watch chargers and one for USB Apple Watch chargers. Make sure you select the version that you need.

This print requires double sided tape. See Amazon link below for adhesive which doesn't leave residue. Folded over duct tape will work just fine if damaging the underlying surface is not a concern.

Print Recommendations

Print Material: PLA (PETG works as well)

Infill Percent: 15%

Perimeters: 2

Layer Height: .15 (higher layer heights work just fine, but layers become more visible)

Supports: YES (Use grid supports. The included .3mf file has paint on supports.)

Print orientation: Place the top surface agains the build plate (see Prusa Slicer .3mf file)

Double Sided Tape Required

Amazon Link to 3M .4 inch double sided tape (https://a.co/d/3n44GFr)

• This adhesive twists off easily and doesn't leave residue. See last photo for recommended amount and placement.