Perfect for kitchen hand towels, dish rags, or rubber gloves. Easily mount on the back of a pantry or kitchen cabinet door.

Print Recommendations

Print Material: PETG only. This design relies on the semi flexible properties of PETG.

Infill Percent: 20%

Perimeters: 3

Layer Height: .2 (higher layer heights work just fine, but layers become more visible)

Print Orientation: Place the side of the clip on the build plate (see Prusa Slicer file for orientation)

Supports: NONE

Assembly

Add a 3M Command Strip to the back of the Dish Towel Hanger (see photo to make sure it is placed on the correct side). Orient the clip facing downward, stick it on a wall, and let sit for a few hours before use to make sure the adhesive sets.

Additional Parts Required 3M Command Strip Required

• Amazon Link to Command Strips https://a.co/d/94eR2Rz Tip: you can cut off the exposed 3M tab for a cleaner look when mounting.