SLASH your way through your tasks with Tiny Wolverine Clawz.

Based on Wolverine's Iconic Tiger Stripe Suit, these mini finger toppers are sure to bring back memories of everyone's favourite crime fighting mutant!

If you enjoy this model, please consider subscribing to my Patreon. It helps me immensely! https://www.patreon.com/NadrojTheGinger

Please Note: The Finger Holes are for an average Adult-Sized index finger, if you are having issues wearing the Clawz, try scaling to meet your needs!

Printed on a (mostly) stock Ender 3 S1 Pro: -20mm/s. 200C Nozzle. 62C Build Plate. -Supports: Yes on exterior of model. I used support blockers in the finger holes. -Build Plate Adhesion: No -0.16mm Layer Height, 2 Walls. 15% Gyroid Infill. 3 Top/Bottom Layers.

**Notes: Due to how thin the claws are, you are going to want to print this SLOWLY. If you do not properly have your Z-Offset dialed in, or if you have over-extrusion issues, you may have difficulty printing. I would recommend enabling z-hop over printed areas to avoid snapping the claws mid-print.

I also rotated the models 75 degrees so the blades of the claws are parallel to the left and right sides of the build plate (shown in pictures). The nozzle was not dragging as much against the tops of the claws while printing after doing this.**