Print-In-Place, No Supports, Articulating Fidget Toy Subscribe To the Mimetics 3D Commercial Tier on Thangs. for rights to sell prints of your cool new friend.

This little axolotl is here to bring a bit more love into your heart this Valentine's Day.

Find Alotl's articulated dragon friend here: https://than.gs/m/996335

Alotl Love, Little Heart Axolotl is the 16th creation in a series of Snap-Flex models by Mimetics 3D, and is available for free for a limited time.

Stay tuned for a keychain version in the near future

Snap-Flex Collection: This articulated fidget toy integrates the Mimetics 3D "Snap-Flex" joint. This allows the model to both move smoothly, mimicking the fluid motion of living creatures, AND stabilize in a firm pose, providing a premium fidgeting experience.

Each SNAP will resonate as a symphony of satisfaction to your ears, confirming your masterful manipulations.

Snap-Flex Instructions: To Lock: Push Body Segments together To Unlock: Pull Body Segments Apart

Tolerance: To accommodate different printer settings and filaments, I’m uploading 3 different tolerance levels of this model to ensure that you get the best fitting, most satisfying “SNAP” with each of your prints.

This is the Loose tolerance model. For the other tolerances, please check out the other versions of the model below:

Tight Tolerance Alotl Love: https://than.gs/m/994472 Medium Tolerance Alotl Love: https://than.gs/m/994480 Loose Tolerance Alotl Love: https://than.gs/m/994484

Please try out each to see what works best for you, and let me know which version you prefer!

Make sure to revisit frequently for more thrilling Snap-Flex models to come. I'm eager to hear your feedback and collaborate on refining this model going forward.

This model is for personal use only. If you're interested in selling physical prints of this model, please subscribe to the Mimetics 3D Commercial Tier on Thangs.

This mini little monster is excited to bring a bit more love into your life

Other Models: For another articulated dragon, check out:

Tight Tolerance Val, Baby Love Dragon: https://than.gs/m/996332 Medium Tolerance Val, Baby Love Dragon: https://than.gs/m/996335 Loose Tolerance Val, Baby Love Dragon: https://than.gs/m/996336

Print Settings: 0.2mm Layer Height 3 Wall Loops 3 Top Shell Layers Good Bed Adhesion Required - Consider using glue stick or a brim

Suggested Material: PLA or PLA+ Note: Silk PLA is too weak to hold up to repeated use of the Snap-Flex joint. Use silks at your own risk

No Supports, Print-In-Place at 100% scale Printing any smaller may disable the Snap-Flex joint.

Printing larger than 100% will make the snap louder AND harder to pop, so be sure to do a shorter test print to make sure it's not TOO hard to snap into place.

These tolerances are TIGHT and you'll likely have to snap each segment a few times before it's loose enough to snap/unsnap easily. I recommend you use regular PLA or PLA+. ABS might be even better, but I haven't tried it yet.

If you print this in resin, please let me know how it turns out. I imagine you would need a more flexible/less stiff resin for it to work appropriately.