End Connectors: These are used to connect the modules on the ends for added stability. I have added connectors for the front and back ranging from 2 - 4 module units.
Instructions for Printing: Raft = no Brim = optional but not needed Wall Loops/Top and Bottom shells = 2 - 4 (personally i like 4 for extra stability) Layer Height = 0.2 mm Speed = Default Temperature = Default for your material of choice
During testing I used the Bambu Labs x1 Carbon with PolyLight PLA and left most settings in the Bambu Studio as default with any changes listed above so your print times may vary.
2 hole slots: Material = roughly 25 grams Time = 50 minutes Material and time includes the Bambu X1 Carbon prep time and flow lines