Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:2343612.

This is a replacement silicone cover for the original E3D V6 (new version). The original cover does not stay where it should be.

Just print all 3 parts, connect them and mold your cover.

Instructions: Print everything with about 20%-25% infill. You should print the parts with 0.1mm layer height for a smoother finish.

To fill the silicone into the mold I use these needles and a normal syringe http://bit.ly/3Fx9dtq

Wait about 2 hours till the silicone is dry to clean everything.

BOM: 4x M2 x 8mm screw https://bit.ly/3UpC1tr

4x M3 x 8mm screw https://bit.ly/3izqOcy

1x 6mm metal pipe

1x silicone (shore 33 up to 450 degree Celsius) https://goo.gl/yVxw4y