Knurled Fidget Bolt Keychain

This design prints in 3 separate pieces: The bolt, the cap, and the spinner. I included 2 versions of the bolt, a shorter version and a longer version. The cap and spinner work for either.

-The bolt is hollowed to allow the storage of "hand-rolled cigarettes" or a little bit of cash. -The cap is reverse-threaded to avoid losing it from the action of the spinner, and to make getting into the "hidden" storage a little less obvious. -Mix and match colors to make your perfect fidget bolt.

These files were uploaded with a non-commercial license. If you would like to sell prints of this design, you can join my Patreon community and sell the fidget keychain or prints of any of my other models!

https://www.patreon.com/thinair3D

Here are the 3d printing settings I used: No Supports Nozzle Size: I have tested these with 0.4 and 0.6 size nozzles and they print great. I don't know about anything bigger. Layer height: The lower the layer height the smoother it will be, but I print them at 0.20 and they work great. Scaling: I haven't tried printing it at different scales, but I wouldn't scale down too much or the clearances may have issues. Scaling up should be ok.