Hi all

Every year we give flowers to our mom; but flower wither al the time. So i was thinking to make some useful flowers, that don't need water.

But only flowers would be boring, so i made them magnetic and that way it's possible to use them on your fridge or other magnetic surfaces.

The flower are designed that a AMS is not needed, the colors can be changed with manual color changes. (instruction below)

Offcourse you can choose your own colors for the flowers.

The plate with the stems can be printed without support, but make sure that bridging is enabled.

The magnets i used are diameter 10mm x 3mm thick. The holes in the stems are 3mm deep on the flowers 1.5mm, that for easy removal when used on flat surfaces. Use strong glue and check the polarities

Magnets: 10mmx3 Magnets on amazon

Colorchanges by plate (choose your own favorite colors)

Plate 1 - Flowermagnet.stl (3 colors)

Start with color of your choice

1st change at layer 11

2nd change layer 14

Plate 3 - Flowermagnet2.stl (4 colors)

Start with color of your choice

1st change at layer 11

2nd change at layer 14

3th change at layet 17

Plate 4 - Flowermagnet3.stl (4 colors)

Start with color of your choice

1st change at layer 11

2nd change at layer 14

3th change at layet 17

Plate 5 - Flowermagnet5.stl (3colors)

Start with color of your choice

1st change at layer 11

2nd change at layer 14

Plate 6 - Flowermagnet4.stl (3 colors)

Start with color of your choice

1st change at layer 11

2nd change at layer 14

Plate 7 - Flower holder - optional (2 colors)

Start with red (i used silk red from esun)

Change at layer 203 to white

Dont forget to share your makes and check my other models.